FDL-3: Nose/Tail Assembly
Required Tools

#2 Phillips Screwdriver
Instructions

-
FDL-3 Nose (Shorty/Forty/Full)
-
FDL-3 Tail (Auto/Semi)
-
(4) 6-32 x 3/8" Machine Screws
-
(2) 6-32 x 1/2" Machine Screws
Prep
Locate the following:

-
Remove (2) 6-32 x 3/8" screws from upper cowl
-
Remove upper cowl from nose
-
Remove (2) 6-32 thumb screws from mid cap (battery cover)
-
Remove mid cap from tail
Step 1

Remove Upper Cowl and Mid Cap

-
Carefully connect the nose to tail ensuring no wires are pinched or damaged
-
Secure at side panels with (4) 6-32 x 3/8" machine screws
-
Secure at underbelly with (2) 6-32 x 1/2" machine screws
Step 2

Connect Nose and Tail

-
Group ESC, 12V and power switch wires
-
Tuck wires into rectangular opening in ESC housing to neaten
Step 3

Prepare Wires

-
Connect ESC, 12V and power switch wires to power board at rear of nose
-
ESC and 12V orientation/color direction IS CRITICAL!!!
-
Miswiring at this stage can and will damage the blaster.
-
Double check that you have not miswired anything
-
Check again
-
Check again!
Step 4

Connect WIres

-
Fold excess wire slack from tail wiring forward
-
Replace upper cowl
-
Secure with (2) 6-32 x 3/8" machine screws
Step 5

Replace Upper Cowl

-
Replace mid cap (battery cover)
-
Ensure notch in corner of mid cap is facing forward
-
Secure with (2) 6-32 thumb screws
Step 6

Replace Mid Cap

You have successfully connected an FDL-3 nose and tail!
Who's the big winner? You are