FDL-3: Nose/Tail Disassembly
Required Tools

#2 Phillips Screwdriver
Instructions

-
Nose/Tail Compatible FDL-3 Blaster
Prep
Locate the following:

-
Remove (2) 6-32 x 3/8" screws from the upper cowl
-
Carefully remove the upper cowl
Step 1

Remove Upper Cowl

-
Remove (2) 6-32 thumb screws from mid cap (battery cover)
-
Carefully remove mid cap
-
If present, carefully remove battery
Step 2

Remove Mid Cap (Battery Cover)

-
Unplug ESC (white/red/black), 12V (red/black) and power switch (black/black) cables from rear of nose section.
Step 3

Unplug Cables

-
Remove (4) 6-32 x 3/8" screws from front of side panels (2 on each side of blaster)
-
Remove (2) 6-32 x 1/2" screws from front of underbelly (2 on each side of blaster)
Step 4

Remove Mid Blaster Screws

-
Carefully separate nose and tail of blaster
-
Uh oh, you broke it, you have successfully separated your FDL-3 blaster into a nose and a tail!
Step 5
